Benelli m2 forend pdf#

The newer ones have to be modified to ghost load. Shop our vast selection and save Enable Accessibility. Depending on how old the M1 is you might be able to ghost load a round in the gun to increase capacity by one. Brownells is your source for Benelli Forend Cap at Brownells parts and accessories. Other than that everything else is cosmetic.Д®TA. I have never had a problem with any warping of the forearm so I don't think you have anything to worry about. I have had my 20-gauge M2 for several years. In 20-gauge it comes with what Benelli calls 'Grip-Tight' coating and it doesn't have the plastic feel. It's not a deal breaker but it works better for my hand. The only alternative I know of is the non 'American' M2. M2 has the comfortec stock which again might just be snake oil, but the grip on the M2 stock has a more curved grip compared to the M1 which I prefer. I really don't know if it makes the difference Benelli says its does, I had no problem breaking clays and killing birds with my old M1. The M2 will also have a SS recoil spring whereas the M1 doesn't(if it still has the stock spring in it). I've never had any issues with the plastic guard other than it doesn't fit as tight in the receiver as the older aluminum guards did, which isn't really that bad as it makes disassembly easier. The trigger guard on the M1 is aluminum and on the M2 it's plastic. WARNING: gun can be unloaded by repeating the operation, as described under point B, this section above, of the chapter: вЂќCartridge replacementвЂќ. 27) the carrier latch must be pressed for each released cartridge. 26).Д¤) The cartridges will be released one by one into your hand (fig. 24).ДЈ) Reverse the gun, and, thrusting the carrier down, press the cartridge retaining lever from the front with the hand index finger (fig. 25).Дў) Gently release the cocking lever to close the breech block (fig. 23): the cartridge in the chamber is extracted and ejected (fig. To unload the shotgun, proceed as follows:ДЎ) Engage the safety catch and pull the cocking lever to open the bolt (fig. (This operation must be carried out with the gun safety catch engaged - see вЂњSafety catchвЂќ and the barrel pointed in safe direction)

Benelli m2 forend pdf#

This is from the factory M2 manual I have in pdf form. You are incorrect about unloading through the loading port. My M1 is in NFA jail so I am limited on comparing it with my M2.